Boil Over...

Discussion in 'Homebrewing' started by maltmuncher, Nov 24, 2012.

Thread Status:
Not open for further replies.
  1. maltmuncher

    maltmuncher Initiate (0) Aug 22, 2012

    You know your wife is cool when even this did not phase her:
    [​IMG]
    Now if I could just her to clean it instead of me :slight_frown:
    Any suggestions on what is best to scrub burnt wort off the stove, such as a cleaning chemical / agent?
     
  2. JackHorzempa

    JackHorzempa Grand Pooh-Bah (3,375) Dec 15, 2005 Pennsylvania
    Society Pooh-Bah

    psnydez86 and SBuchan like this.
  3. DubbelMan

    DubbelMan Initiate (0) Mar 17, 2009 New York

    Wow that's nasty! I have a feeling whatever you do its going to be tough. I suggest barkeepers friend. But I dont know. Thats pretty bad.:grimacing:

    Good luck!
     
  4. maltmuncher

    maltmuncher Initiate (0) Aug 22, 2012

    I could try these but this stuff is thick and burnt on to a crisp-it would seem like those magic clean items would just get tore to shreds...
     
  5. JackHorzempa

    JackHorzempa Grand Pooh-Bah (3,375) Dec 15, 2005 Pennsylvania
    Society Pooh-Bah

    Yeah, the Mr. Clean eraser is not very durable.

    Two thoughts:

    · Squeeze the cleaner solution from the Mr, Clean eraser sponge onto the baked mess and let it sit a awhile to ‘dissolve’ the baked on mess
    · Go the Comet (or cleanser of your choice) and Green Scrubber route. The Green Scrubbers are pretty durable (but will also break down with lots of scrubbing of baked on stuff).

    Cheers!
     
  6. messyhair42

    messyhair42 Initiate (0) Dec 30, 2010 Colorado

    When elbow grease and cleaning agents won't do the job I find a spoon will scrape off the worst of it.
     
  7. cmmcdonn

    cmmcdonn Initiate (0) Jun 21, 2009 Virginia

    A razor blade on the ceramic surfaces works wonders for the thick stuff.
     
  8. kscaldef

    kscaldef Initiate (0) Jun 11, 2010 Oregon

    Yeah, I think you'll probably need an abrasive cleaner like Barkeepers Friend, Bon Ami, or Comet. Just test it first and make sure it's not going to strip the finish off the stove top.
     
  9. scurvy311

    scurvy311 Savant (1,135) Dec 3, 2005 Louisiana

    Would oven cleaner work if he sprayed it on and let it sit...possibly remove the top and take it outside to clean...?
     
    billandsuz and bgjohnston like this.
  10. atomeyes

    atomeyes Initiate (0) Jul 13, 2011 Canada (ON)

    a dozen roses works really well
     
  11. beertographer

    beertographer Initiate (0) Aug 19, 2011 Colorado

    I accidentally started a small fire in my kitchen and these things worked wonders getting rid of smoke damage on the walls. I'm pretty sure they can clean anything... with the exception of souls.
     
  12. barfdiggs

    barfdiggs Initiate (0) Mar 22, 2011 California

    Brillo pad. Then magic eraser.
     
    goodonezach likes this.
  13. maltmuncher

    maltmuncher Initiate (0) Aug 22, 2012

    Just a waste of money at this point, cause she could care less about the stove-she wants a new one anyhow.... Just dont want to spend the money for it. :slight_smile:
     
  14. bgjohnston

    bgjohnston Initiate (0) Jan 14, 2009 Connecticut

    I have used oven cleaner on enameled surfaces like that and gotten things at least back under control. It is best if you can remove the part and do it outside, preferably where it can sit overnight.
     
  15. goodonezach

    goodonezach Initiate (0) Mar 24, 2011 New York

    hot water might get some of that stuff to dissolve but brillo's prob your best bet.
     
  16. hopfenunmaltz

    hopfenunmaltz Pooh-Bah (2,635) Jun 8, 2005 Michigan
    Pooh-Bah

    A thick solution of Barkeepers Friend. Green Scrubby after a soak.
     
  17. billandsuz

    billandsuz Pooh-Bah (2,097) Sep 1, 2004 New York
    Pooh-Bah

    oven cleaner will work. youll need to let it sit and it might take a few passes, but it will eventually get all of it off.

    the industrial oven cleaner from a restaurant supply, or even the heavy duty oven cleaner from lowes depot will work. i have found the heavy duty stuff to work alot better than the average stuff, but the fumes can be quite toxic and uncomfortable. if you cant take the top off and spray it down on the deck or somewhere, plan to spray it and be out of the house for the afternoon. spread newspaper around the area that you don't want to overspray. and use crumpled newspaper to mop up the mess. or an old bath towel. or 2 or 3. or a whole roll of paper towels. hosing the mess off is really alot easier.

    and wear rubber gloves!

    you can try to bake it off too. if you get that sugary mess hot enough it will eventually turn to 100% carbon. that will flake off a bit easier. though unless you have a pizza oven i cant see that happening.

    no matter what, you really made yourself a hell of a mess. happens to everyone. even a small boil over is a giant pita.
    good luck.
     
  18. JackHorzempa

    JackHorzempa Grand Pooh-Bah (3,375) Dec 15, 2005 Pennsylvania
    Society Pooh-Bah

    “you can try to bake it off too. if you get that sugary mess hot enough it will eventually turn to 100% carbon. that will flake off a bit easier. though unless you have a pizza oven i cant see that happening.”

    There’s an idea! How about heading over to your local pizzeria with your stove top and some homebrews in hand (as compensation) and ask them if they could bake your stove top for you!?! That would be a great story for all involved!:slight_smile:

    Cheers!
     
  19. SFACRKnight

    SFACRKnight Grand Pooh-Bah (3,348) Jan 20, 2012 Colorado
    Pooh-Bah Trader

    Pumic stone works great for the gnarly stains on my ceramic surfaces followed by the magic eraser.
     
  20. maltmuncher

    maltmuncher Initiate (0) Aug 22, 2012

    OK so its clean.... I used a combination of suggestions. I happen to have most of the items everyone suggested already laying around for everyday cleaning and they worked great for the bulk of it.

    However, towards the end the most burnt parts were smooth as could be, cleaner would not penetrate them and using too much elbow-grease was getting me worried about scratching the surface.

    So I had a crazy idea and thought I would share it with everyone... closer to the burners still had black areas that would just not clean... I had some 3020 sandpaper in the garage from some fine and wet sanding I was doing. Well I basically wet-sanded using all purpose kitchen cleaner (409) and the worst stops came right up. No scratch, nicks or surface change in any way. :grimacing:

    Wish I thought about this before the hour or so I had already spent scrubbing the damn thing. :grinning:
     
Thread Status:
Not open for further replies.