Good Kegging Deal?

Discussion in 'Homebrewing' started by MrTCS, May 30, 2016.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. VikeMan

    VikeMan Grand Pooh-Bah (3,067) Jul 12, 2009 Pennsylvania
    Pooh-Bah

    There is a sticky thread on a different forum that lists all the standard corny keg O-Ring Sizes. It's a forum where they Talk about Homebrew. You might say it's full of Homebrew Talk.
     
    #21 VikeMan, Jun 3, 2016
    MrTCS likes this.
  2. inchrisin

    inchrisin Pooh-Bah (2,013) Sep 25, 2008 Indiana
    Pooh-Bah


    I just called them. :slight_smile:

    I believe a few of the guys prowling this forum know the sizes as well.
     
    #22 inchrisin, Jun 3, 2016
    MrTCS likes this.
  3. MrTCS

    MrTCS Initiate (0) Mar 6, 2014 Indiana

    I got my regulator in today and everything hooked up to pressure test the kegs overnight. They filled up fine and I didn't detect any leaks after applying a lot of Starsan. The only problem is the regulator's third gauge doesn't seem to register anything. Am I missing something or is this one a dud?

    [​IMG]
     
    #23 MrTCS, Jun 7, 2016
  4. PortLargo

    PortLargo Pooh-Bah (1,831) Oct 19, 2012 Florida
    Pooh-Bah

    You're not missing anything . . . it's kaput. Everything from the tank outlet to the primary, then the nipple to the second primary, to the high pressure gauge should have high pressure (600 - 900'ish). If you do the replacement be aware it's left hand thread.
     
    #24 PortLargo, Jun 7, 2016
  5. inchrisin

    inchrisin Pooh-Bah (2,013) Sep 25, 2008 Indiana
    Pooh-Bah


    This is also happening:

    http://shop.greatfermentations.com/...ail&utm_term=0_2d21fccacc-38b5437f50-20008317

    That puts ball lock at ~$50 ea.
     
    #25 inchrisin, Jun 9, 2016
Page 2 of 2
Thread Status:
Not open for further replies.