Keggle Conversions

Discussion in 'Homebrewing' started by BeerBaron, Apr 4, 2012.

Thread Status:
Not open for further replies.
  1. BeerBaron

    BeerBaron Crusader (457) May 30, 2008 Ohio

    I don't have a shop or a garage so I am looking into recommendations for where I can take my sanke (1/2 bbl) to get the top cut off and a hole punched. Looking to see where other people have taken theirs, esp in central Ohio.
     
    #1 BeerBaron, Apr 4, 2012
  2. GreenKrusty101

    GreenKrusty101 Initiate (0) Dec 4, 2008 Nevada

    Might have better luck on the Regional Forum (Great Lakes)...good luck
     
    #2 GreenKrusty101, Apr 4, 2012
  3. dfess1

    dfess1 Initiate (0) May 20, 2003 Pennsylvania

    craigslist? trade some homebrew for the job?
     
    #3 dfess1, Apr 5, 2012
  4. joshodonn

    joshodonn Initiate (0) Jan 21, 2011 Florida

    I just called up a local welding shop and asked if they could cut it off and they were happy to do it, cost about $25 if I recall. Not sure if they'd punch a hole for the ball-valve.
     
    #4 joshodonn, Apr 5, 2012
Thread Status:
Not open for further replies.