Running 3 banjo burners

Discussion in 'Homebrewing' started by LBHops62, Apr 27, 2012.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. hopfenunmaltz

    hopfenunmaltz Pooh-Bah (2,647) Jun 8, 2005 Michigan
    Pooh-Bah

    The only time is when I knock of the D plates loose while stiring the mash. Make sure they fit tight, then no problems.
     
    #21 hopfenunmaltz, May 1, 2012
  2. LBHops62

    LBHops62 Initiate (0) Apr 22, 2010 Georgia

    Cool Thanks! I'll try that!
     
    #22 LBHops62, May 1, 2012
  3. dfess1

    dfess1 Initiate (0) May 20, 2003 Pennsylvania

    My ignitors are just bbq ignitors. push the button to close the loop and provide a spark. The burners themselves ride up and down the rear support behind each burner. Spin a nut and it raises/lowers the burners. That said, I haven't really touched them since initially setting them ( I think 3 inches or so). This also gets mounted onto my smoker and is used as a three burner stove top at bbq/camping sessions. So I figured where I want a burner for brewing may not be the same height as for say a sautee pan.
     
    #23 dfess1, May 1, 2012
Page 2 of 2
Thread Status:
Not open for further replies.